This is from a post to the MailingList by DonPark about how he got his Linux laptop to connect to his Linux desktop in AdHocMode. -- AdamShand
----
As far as hardware let me get this one point out of the way. If you are trying to make your own home networking wireless setup, buy a [[http://www.orinocowireless.com/template.html?section=m57&page=128&envelope=93|PC PCMCIA Adapter]]:
<<BR>>For around $25 (on eBay) it gives your PC PCMCIA slots! Meaning that it can let a desktop PC make use of the PCMCIA wireless cards.
<<BR>>[[http://search.ebay.com/search/search.dll?MfcISAPICommand=GetResult&ht=1&SortProperty=MetaEndSort&query=pci+pcmcia+adapter|Search eBay for PCI to PCMCIA]]
<<BR>>[[http://search.ebay.com/search/search.dll?MfcISAPICommand=GetResult&ht=1&SortProperty=MetaEndSort&query=ISA+pcmcia+adapter|Search eBay for ISA to PCMCIA]]
<<BR>>

'''The Linux based home access point setup'''

Desktop (aka. 'The Base station'):
 *Hardware:
  * Pentium 166, 96MB
  * ISA (or PCI) to PCMCIA adapter
  * Orinoco Turbo Bronze
 * Software:
  * Linux 2.4.3 (Mandrake 8.0)
   * wireless-tools-20-4mdk.rpm
   * kernel-pcmcia-cs-2.4.3-20mdk.rpm

Laptop
 * Hardware
  * IBM Thinkpad 760XL (Pentium 166)
  * Cisco Aironet 340
 * Software
  * Linux 2.4.3 (Mandrake 8.0)
   * wireless-tools-20-4mdk.rpm
   * kernel-pcmcia-cs-2.4.3-20mdk.rpm (same as the base station)

'''Configuration:'''

Assuming the PcmciaCard inserts OK and you get two beeps (needs to be "beep ... beep" not "beep ... boop"), the only config I did at the base station was:

 {{{# iwconfig eth1 essid klickitat.yi.org mode ad-hoc
}}}

The laptop gets a similar config.  The rate is lowered for the bronze card. Its probably not necessary for folxs with newer wireless cards. Im not sure if Im getting more distance out of this slower speed. It could be a good thing.

 {{{# iwconfig eth0 essid klickitat.yi.org mode ad-hoc rate 2M
}}}

Then its just your usual run-of-the-mill IP configuration :). All Id say here is to create a new subnet for use with all wireless devices. If the base station is 192.168.0.4 and you give the laptop/whatever 192.168.0.5 you'll have to add a static route for just that IP to go out the pcmcia
card. its easier to give the air near your base station its own chunk of addresses (eg 192.168.1.x).

-- DonPark

PS. I dont have any relation to the seller of the ISA/PCMCIA device. I just know its cheap and it works. let the buyer beware.

----
[CategoryExample]