- Pick location for next weekly
- Node notes:
NodeWygant -- replaced a Buffalo WZR600DHP with an Alix 2 on Saturday evening following an outage related to a flash chip. Then reflashed to Ubiquiti Bullet on the roof.
NodeEcotrust -- Cisco still needs replacement with a Cisco Meraki MR24.
NodeLuckyLabNorth -- reflashed the Netgear WNDR3800 with modern LEDE to improve tools available.
NodeHawthorne -- Steve went by today and talked to Talbot, and called me. I asked if he could see our network and he said yes, so it is still plugged into power, just not a network.
NodeNewDeal -- reflashed with current bits
NodeTibbetts -- reflashed with current bits
NodeKeegan -- still no word from Keegan
NodeGarfield -- still no word from Max Orhai
NodeMatt -- still no word from Matt Gumble
NodeSechzig -- need to send an invoice to VZA Homes
NodeSlyness -- haven't heard from Aaron in the last few weeks
- new node site survey near West Burnside and 23rd
- Discussion of outreach ideas Bergie and Russell heard from Luka.
In the wake of LukaMustafa's demo, interest in building a KORUZA link?
Your Item Here
- Node notes:
general node firmware updates - strived to update oldest, after NodeWygant failure
NodeGooseHollow - Splash page still not enabled
NodePioneerSquare - NanoStationM2P stock firmware was only providing admin interface SSLv3.
- Also stock firmware 2.5 allows upgrades to OpenWRT/LEDE, current does not.
- Possibly replace AP to overcome snmp and memory issue.
NodeWygant replaced, cable still disconnected, also flashed Ubiquiti
NodeEcotrust - need to make contact
NodeHawthorne - should stop by Bazi next week, collect HW, ort
NodeSechzig - need to invoice
VZA Homes now has an arrangement with LivingRoomRealty
Potential node is at 209 NW 23rd (original contact said 21st) JayWickizer is contact
We pressed LukaMustafa for ideas useful to bring in new members
Discussion with Tomas about FooCabFirmwareHowTo and initial build
- Do Comcast consumer caps (1TB/mo beginning November 1) affect any nodes
Koruza - where can we use it? JasonBergstrom want's to buy the GoodEnoughCNC