Differences between revisions 6 and 7
Revision 6 as of 2001-12-11 18:46:47
Size: 1995
Editor: user-uini6s7
Comment:
Revision 7 as of 2001-12-11 18:47:51
Size: 2001
Editor: user-uini6s7
Comment:
Deletions are marked like this. Additions are marked like this.
Line 3: Line 3:
 * Tarball:
  * http://www.personaltelco.net/download/warez/debian-ap-20011211.tar.bz2
 * Image (dd, requires 340mb drive):
 * http://www.personaltelco.net/download/warez/debian-ap-20011210.img.bz2
 * The [http://www.personaltelco.net/download/warez/debian-ap-20011211.tar.bz2 tarball]
 * A {{{dd}}} [http://www.personaltelco.net/download/warez/debian-ap-20011210.img.bz2 image] (requires a 340mb drive).

This document goes hand in hand with the DebianLinuxAccessPoint page. Once your image is created this shows you how to load the image onto a FujitsuStylistic1000. You can download it in two formats:

If you think that you've found a bug in the image please report it on the DebianApImageBugs page, make sure you include enough information for me to duplicate it. -- AdamShand

See also: HostApMode

  1. Put drive in laptop, it should show up as /dev/hde (if it doesn't you'll need to adjust the rest of the document accordingly).
  2. Format the disk (if you don't have cfdisk, normal fdisk will do just fine):

    # cfdisk /dev/hde I set my partition table up like this and it seems to work fairly well. {{{hde1 Boot Primary Linux 299.93

hde2 Primary Linux swap 41.15}}}

  • Format the filesystem (we'll upgrade to EXT3 later):

    # mke2fs /dev/hde1

  • Mount the drive:

    # mount /dev/hde1 /mnt

  • Untar the image onto the drive (note the image is compressed with bzip2 so it will require a recent version of tar and the bunzip2 utility), on my laptop this takes 2 or 3 minutes:

    # tar Ixvf /mnt/debian-ap-image-yyyymmdd.tar.bz2 -C /mnt

  • Chroot into the mount point so that you can

    # chroot /mnt

  • Update the filesystem to support EXT3:

    # tune2fs -j /dev/hde1

  • Modify /mnt/etc/lilo.conf so the top section reflects the current device name of the drive
  • Make the image bootable with lilo (first # exit out of the chroot'ed environment):

    # lilo -r /mnt -C /etc/lilo.conf

  • Boot the drive up in the Stylistic and then install grub (do this on the Stylistic):

    # grub-install 


[CategoryDocumentation]

DebianApImage (last edited 2012-03-11 02:31:15 by RussellSenior)