Differences between revisions 14 and 15
Revision 14 as of 2003-10-30 23:57:44
Size: 5732
Editor: dsl-208-151-246-210
Comment:
Revision 15 as of 2003-10-31 00:01:30
Size: 6007
Editor: dsl-208-151-246-210
Comment:
Deletions are marked like this. Additions are marked like this.
Line 80: Line 80:
{{{ '' eth0 Link encap:Ethernet HWaddr 00:C0:F0:17:74:F6
          inet addr:192.168.100.3 Bcast:192.168.100.255
           Mask:255.255.255.0
           UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
           RX packets:2092 errors:0 dropped:0 overruns:0 frame:0
           TX packets:1102 errors:0 dropped:0 overruns:0 carrier:0
           collisions:2 txqueuelen:100
           RX bytes:2948521 (2.8 MiB) TX bytes:78364 (76.5 KiB)
           Interrupt:10 Base address:0xe880
     {{{ eth0 Link encap:Ethernet HWaddr 00:C0:F0:17:74:F6
               inet addr:192.168.100.3 Bcast:192.168.100.255
                Mask:255.255.255.0
      UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
                RX packets:2092 errors:0 dropped:0 overruns:0 frame:0
                TX packets:1102 errors:0 dropped:0 overruns:0 carrier:0
      collisions:2 txqueuelen:100
                RX bytes:2948521 (2.8 MiB) TX bytes:78364 (76.5 KiB)
                Interrupt:10 Base address:0xe880
Line 90: Line 90:
eth1 Link encap:Ethernet HWaddr 00:00:F8:04:F2:9F
           BROADCAST MULTICAST MTU:1500 Metric:1
           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
           collisions:0 txqueuelen:100
           RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
           Interrupt:11 Base address:0xec00

lo Link encap:Local Loopback
           inet addr:127.0.0.1 Mask:255.0.0.0
           UP LOOPBACK RUNNING MTU:16436 Metric:1
           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
           collisions:0 txqueuelen:0
           RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) '' }}}
     eth1 Link encap:Ethernet HWaddr 00:00:F8:04:F2:9F
      BROADCAST MULTICAST MTU:1500 Metric:1
                RX packets:0 errors:0 dropped:0 overruns:0 frame:0
                TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:100
                RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
                Interrupt:11 Base address:0xec00
           lo Link encap:Local Loopback
      inet addr:127.0.0.1 Mask:255.0.0.0
      UP LOOPBACK RUNNING MTU:16436 Metric:1
                RX packets:0 errors:0 dropped:0 overruns:0 frame:0
                TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
      collisions:0 txqueuelen:0
                RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) }}}
Line 108: Line 108:
{{{''We trust you have received the usual lecture from the local System
Administrator. It usually boils down to these two things:
     {{{''We trust you have received the usual lecture from the local System
     Administrator. It usually boils down to these two things:
Line 111: Line 111:
         #1) Respect the privacy of others.
         #2) Think before you type.
      #1) Respect the privacy of others.
              #2) Think before you type.
Line 114: Line 114:
Password:''}}}      Password:''}}}
Line 124: Line 124:
{{{''main/admin sudo
main/net ssh
main/admin pciutils
main/utils fileutils
main/utils shellutils
main/utils textutils
main/utils gnupg
main/net dnsmasq
main/net snmpd
main/base lilo
main/net iptables
main/devel make
main/editors nvi
main/admin deborphan''}}}
     {{{''main/admin sudo
     main/net ssh
     main/admin pciutils
     main/utils fileutils
     main/utils shellutils
     main/utils textutils
     main/utils gnupg
     main/net dnsmasq
     main/net snmpd
     main/base lilo
     main/net iptables
     main/devel make
     main/editors nvi
     main/admin deborphan''}}}
Line 153: Line 153:
{{{ ''do_symlinks = No
do_initrd = Yes
     {{{ ''do_symlinks = No
     do_initrd = Yes
Line 156: Line 156:
postinst_hook = /sbin/update-grub
postrm_hook = /sbin/update-grub
do_bootloader = No''}}}
     postinst_hook = /sbin/update-grub
     postrm_hook = /sbin/update-grub
     do_bootloader = No''}}}
Line 161: Line 161:
 *  dpkg -P lilo  * dpkg -P lilo
Line 164: Line 164:
{{{''Could not find /boot/grub/menu.lst file. Would you like
/boot/grub/menu.lst generated for you? (y/N) y''}}}
     {{{''Could not find /boot/grub/menu.lst file. Would you like
     /boot/grub/menu.lst generated for you? (y/N) y''}}}
Line 186: Line 186:
{{{-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
                   Congratulations!
   NoCat gateway is installed. To start it, check
   /usr/local/nocat/nocat.conf, then run bin/gateway
   as root.
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-}}}
     {{{-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
                        Congratulations!
      NoCat gateway is installed. To start it, check
        /usr/local/nocat/nocat.conf, then run bin/gateway
        as root.
     -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-}}}

Here in will be the recipe needed to install a clean, effecient and viable build of Debian, NoCat and related apps to turn a NewCloneArmyBox into a powerfull node on the PTPnet

(These are rough notes taken by JeffWillard and DarrinEden from the actions of KeeganQuinn which will be hammered into a step by step recipe)

The Debian Install

  • at boot prompt: "bf24" (start 2.4 kernel vs. 2.2)
  • select Language and keyboard
  • hard disk (/dev/hda)
    • Create swap partition (128M)
    • Root partition --bootable (128Mb)
    • logic partition (.5 Gig)
    • 2nd logic (.5 Gig)
    • home (whatever is left over)
    • all FS type Linux exect swap which is linux swap

    • Init swap partition
    • init pri (ext3)
    • mount root filesystem
    • repeat above for var,usr,and home

  • kernel install
    • configure device drivers
    • (devices/net)
    • nic (de4x5)
  • configure network
  • make system bootable --mbr
  • reboot
  • set time
  • set root pwd
  • remove pcmcia packages? yes
  • atp configuration ---edit by hand
  • run taskel? --no
  • deselect? --no
  • update configuration file? yes
  • Configuring debconf
    • select Readline
    • select medium
    • don't touch keymap
    • system wide readible directories? yes
    • serial--autosave once
  • upgrade glibc? Y
  • update system? yes
  • mail config? 5
  • mandb? --yes
  • rebuild database? --yes
  • erase any additional .deb files? --yes
  • "apt-get update"
  • "apt-get install deborphan"
  • "deborphan"
  • "dbkp -P <all packages listed ---space in between>"

  • "deborphan -a"
  • "dpkg -P <all packages you don't want>"

  • "deborphan -a"
    • repeat several times to ensure all packages are removed that you don't want

NoCat Setup

Here's the raw capture of the stuff I did to the second box. There's a little fu that didn't get captured in a vi session, but forthe most part...

  • "clear"
  • "/sbin/ifconfig -a"BR

    • {{{ eth0 Link encap:Ethernet HWaddr 00:C0:F0:17:74:F6
      • inet addr:192.168.100.3 Bcast:192.168.100.255

        • Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:2092 errors:0 dropped:0 overruns:0 frame:0 TX packets:1102 errors:0 dropped:0 overruns:0 carrier:0 collisions:2 txqueuelen:100 RX bytes:2948521 (2.8 MiB) TX bytes:78364 (76.5 KiB) Interrupt:10 Base address:0xe880

      eth1 Link encap:Ethernet HWaddr 00:00:F8:04:F2:9F
      • BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) Interrupt:11 Base address:0xec00

      lo Link encap:Local Loopback
      • inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) }}}

  • "sudo su -"
    • {{{We trust you have received the usual lecture from the local System Administrator. It usually boils down to these two things:

      • #1) Respect the privacy of others. #2) Think before you type.

      Password:}}}

  • "exit"
  • "logout"
  • "sudo -s"
  • "clear"
  • "apt-get install snmpd dnsmasq"
  • "apt-get install perl make gnupg"
  • "deborphan -a"
    • {{{main/admin sudo main/net ssh main/admin pciutils main/utils fileutils main/utils shellutils main/utils textutils main/utils gnupg main/net dnsmasq main/net snmpd main/base lilo main/net iptables main/devel make main/editors nvi main/admin deborphan}}}

  • "lynx http://www.nocat.net"

    • Download the nightly build of NoCatAuth

    • exit lynx
  • "tar xvfz NoCatAuth-nightly.tgz"

  • apt-get install wget
  • wget http://rune.thebasement.org/~ice/tmp/stable-01.patch

  • apt-get install patch
  • patch -p1 < ../stable-01.patch

  • vi /etc/kernel-img.conf
    • {{{ do_symlinks = No do_initrd = Yes postinst_hook = /sbin/update-grub postrm_hook = /sbin/update-grub

      do_bootloader = No}}}

  • apt-get install kernel-image-2.4-K6
  • dpkg -P lilo
  • apt-get install grub
  • update-grub
    • {{{Could not find /boot/grub/menu.lst file. Would you like /boot/grub/menu.lst generated for you? (y/N) y}}}

  • update-grub
  • reboot
  • uname -a
  • sudo -s
  • apt-get install ssmtp
    • Automatically overwrite config files? y
    • Who gets mail for userids < 1000? dje

    • Name of your mailhub? mail.personaltelco.net
    • What domain to masquerade as? personaltelco.net
    • Allow override of From: line in email header? y
  • deborphan
  • dpkg -P libident libpcre3
  • deborphan
  • make gateway
    • {{{-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
      • Congratulations!
      • NoCat gateway is installed. To start it, check /usr/local/nocat/nocat.conf, then run bin/gateway as root.

      -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-}}}

NewCloneArmyInstallMethodology (last edited 2007-11-23 18:01:02 by localhost)