Node name: The Crow Bar
Live Date: February 2, 2004
Contact: JasonMcArthur

Location

3954 N Mississippi St.
Portland, OR 97227

Map: https://cwnmyr.personaltelco.net/nodes/CrowBar

Equipment

• Netgear WGT634U (on indefinite loan)

Software Installed

• WgtCab

  • OpenWrt Kamikaze r16855

  • NoCatAuth

  • OpenVpn

  • Olsrd
  • Snmpd

Network Configuration

• Hostname: loki
• ESSID: www.personaltelco.net/crowbar
• BSSID: 00:0F:B5:3D:50:09
• Channel: 1
• WAN interface: eth0.1
  • DHCP: 192.168.1.x/24
  • Default route: 192.168.1.1 (DSL modem with public IPaddr: 72.11.112.142)
• Public interface: br-lan (eth0.0 and ath0)
  • IPaddr: 10.11.2.65/26

Clients on the public network are administratively prevented from reaching any hosts on the private network immediately upstream. The port forward that once existed is no more. Device can be reached only locally or over the vpn tunnel.

Installers / Organizers

• TomFitz

• KeeganQuinn

• JasonMcArthur

• This node is managed by the NetworkOperationsTeam.

Maintenance and System Log

• 2010-02-17: The WgtCab (MISSNET-19) had kernel panic'd a few times in a row, decided to replace it. Dropped in a new one that we had initially prepped to go to NodeKentonStation (but haven't heard back from them, so it was available for use here). Used the image previously flashed. Had to patch up the SSID for crowbar. Otherwise, good to go. --RussellSenior

• 2009-07-24: Decommissioned the NuCab (which had been disconnected some time ago) as well as the AP, replaced with WgtCab. It is plugged into their private network, but we are using an iptables rule to prevent access to private network hosts from public network. --RussellSenior

• 2007-09-02: Stopped by to determine why there was no connectivity on eth1 (to the WAP upstairs). Looked like a flakey cat5 connection at the AP end. The bartender said that when there were problems, we reseated the cat5 connection at the access point end. After the connectivity on eth1 returned, I discovered nocat was not working. I eventually traced this to tap0 being identified as one of the internal interfaces. Instead of relying on the automatic determination, I configured nocat.conf to use eth1. After that, nocat began behaving itself. --RussellSenior

• 2007-02-06: Stopped by to check on an outage. The eth0 interface was down. I up'd it and restarted nocatauth-gateway and it started working. --RussellSenior

• 2005-09-24: Upgraded to sarge. (- KeeganQuinn)

Details

Beer and wine, good food, and good solid coverage throughout the establishment. Stop in and pick up a microbrew on tap, and play some pool or pinball.

Good selection of beer and very friendly bartenders. Open 3 p.m. to 2 a.m., 7 days a week.

Enjoy!

Observation Plots

Full size Full size Full size Full size

[CategoryNode]