Size: 1507
Comment:
|
Size: 1809
Comment:
|
Deletions are marked like this. | Additions are marked like this. |
Line 21: | Line 21: |
* |
* NodePatch - failed flash? * 16 - 32G would cause bit reduction, chips are cheap, but can the chips be swapped logically? * NodeMoreRerun - still not installed * NodeRussellJr - in Seattle, not open access * Next week's meeting is the Board meeting at NodeWorldCup, should we swap in an MR24? |
Location: NodeLuckyLabNW
Date and Time: Wednesday, September 6, 2017, 6:30pm-8:00pm
Scribe: You
Roll Call: RussellSenior,TedBrunner,JasonBergstrom,SteveTree
Agenda
- Pick location for next weekly
- Node notes:
NodeEdison -- gear has not yet shipped, backhaul is over FiberFi, not clear they have installed yet either, on-site manager is slightly antsy to get some kind of service, but ... like, no gear. might install a gateway if backhaul is present.
NodePatch -- a power blip in SE Portland left NodePatch's WZR600DHP unhappy and not booting. It was swapped out with a spare (recovered from NodePotatoChampion), and is back online. Original has some squashfs read errors (comparing to the firmware flashed, there are three bits flipped), this results in a not-booting device. The solution might be to just order replacement flash parts and reprogram it. I have grabbed images of the existing flash. The original part is no longer available, but footprint compatible parts are, for about ~$4 each.
NodeMoreRerun -- not installed yet.
- Point map.personaltelco.net at cwnmyr?
Your Item Here
Notes
JasonBergstrom will request (and assist where possible) KeeganQuinn promote cwnmyr as the live map.personaltelco.net
- Node notes:
NodeEdison - FiberFi backhaul, may be installed?, could do temporary install for Charlie inside if FiberFi installed.
NodePatch - failed flash?
- 16 - 32G would cause bit reduction, chips are cheap, but can the chips be swapped logically?
NodeMoreRerun - still not installed
NodeRussellJr - in Seattle, not open access
Next week's meeting is the Board meeting at NodeWorldCup, should we swap in an MR24?