If you are new to all the community networking stuff one of the first questions everybody asks is "What should I buy". Well it depends a little on what you want but here are some general options where we attempt to balance ease of use, cost and future flexibility.
Just wanna get on the network? Well here's a good way to start and make sure you don't get ripped off.
- Laptop with a PCMCIA slot (desktop will work but you'll need a Pcmcia Bridge)
If you're serious about your WarDriving and want a client node with some flexibilty and power, you need to shop around!
- Laptop with a PCMCIA slot
- PCMCIA 802.11b card with external antenna connectors (Lucent or Cisco 350 or Proxim Rangelan?)
- Magnetic mount antenna and cable
The Hacker Node
This is what a lot of us are building now. The downside is that the Sylistic 1000's are 486 based so will not be able to run ExtrusionDetection software very well (if at all). This is an extremely cheap and flexible solution but does require a significant amount of knowledge to put it all together or a bit of stamina to stick out the learning curve.
FujitsuStylistic1000 - (<$100)
- PCMCIA 802.11b card - ($70) Dlink's won't work in a Stylistic 1000(They require a Card Bus slot)
- PCMCIA ethernet card ($15)
NoCatAuth and Linux Host Ap software ($0)
- Antenna and Cable ($75)
Out of the Box Node
Here would be our recommendation if you were happy to spend more money in exchange for a solution which should mostly "just work".
Lucent RG-1000 (<$200)
Any old desktop PC (FreeGeek has many for free)
Linux NoCatAuth Bootable CD (doesn't exist yet