Node name: Buffalo Gap
Live Date: August 11, 2005
Sponsor: The Buffalo Gap Saloon
Contact: Troy Itami, Assistant General Manager (503) 244-7111
The Buffalo Gap Saloon
6835 SW Macadam Ave.
Portland, OR 97219
(503) 244-7111
Map: https://cwnmyr.personaltelco.net/nodes/BuffaloGap
Equipment
- Router: DSL
Server: NuCab (Owned by: Personal Telco, Inc. )
Access Point: NetgearWgt634u (Owned by Buffalo Gap )
- Access Point: Linksys WRT54GSv4 (Owned by Buffalo Gap, upstairs)
Software Installed
Portal: DebianLinux, NoCatAuth
Network Configuration
- ESSID: www.personaltelco.net
- Channel: 11
- BSSID: 00:0F:B5:97:1C:79
- Channel: 11
- IP: ??
BSSID: 00:14:BF:75:9F:4A
- Chanel: 1
- IP: 10.11.9.67/26
- Hostname: buffalogap
- Internet Network: 69.88.124.37/24
- Gateway: 69.88.124.1
- Upstream DNS servers: 64.65.128.6, 66.213.224.2
- PTPnet Network: 10.11.9.64/26
Installers / Organizers
Installed by DarrinEden.
Captive portal configured by KeeganQuinn.
Maintained by the NetworkOperationsTeam.
Maintenance and System Log
2008-11-06: TroyItami ran new cat6 cable and brought in an access point from home, I configured it (turned of dhcp server and set an IP) and plugged it in upstairs. Also plugged in a $10 freegeek special 8-port switch. Seems to be working. --RussellSenior
2007-11-02: RussellSenior, PaulCLeddy, LarryTruman went to check it out. DSL, somewhat flakey, had been reconfigured for bridging, which made the nucab's eth0 ip wrong. Fix, waited for DSL to train, and it started working. Oh yeah, and the Buffalo Gap's POS system (next to the nucab) died about the same time as we were borrowing its monitor for diagnosis, which was awkward. It looked like it's internal power supply failed. I don't think it was anything I did. --RussellSenior
2006-04-12: DonPark and SethShikora go on-site. The netgear on the dining room TV shows no link-light. The nucab in the back office on the "WLAN" ethernet card shows no link light. The cable goes through a doorway that gets pinched when the door is closed. We brought the AP back into the back office on a new, short cable. it works fine. recommended that buffalo gap replace the ethernet cable and drill a conduit for it.
2006-04-10: Internetron is up, but ethernet to the AP is not working, apparently. AaronBaer runs SETUP.sh to sync up keys. --RussellSenior
2006-04-10: Reports on Ops-list that the node isn't working. NuCab doesn't seem to be accessible from the intertron either. - CalebPhillips
2005-12-10: Responded to service request. Seems that they moved some stuff around and it broke everything. At some point TomFitzgerald came in and got the system running in a degraded state. I finished up the job by getting the NuCab back to working - the problem with the NuCab was a misconfigured eth0 - CalebPhillips
2005-10-02: Security updates installed. (- KeeganQuinn)
2005-09-30: Respond to support request. Updating formatting on this page ala NodeAudit. Everything is functional, just doesn't cover entirety of (fairly large) space. - CalebPhillips
2005-08-11: Original Wiki page created. This probably means that the node went up around then. - CalebPhillips
Notes
- 3 pool tables, big screen TV, Galaga. Seems like a great hang-out.
- (Really) nice staff